Check out this sweet ride! James Moore's new 22ft. Kenworth Elite tool truck features a set-back entry door, PACCAR PX-7 engine, Allison 2500HS 6-speed transmission, and air ride suspension and air brakes. This cab chassis tool truck also features slick 7" chrome exhaust stacks with West Coast tips, a 2,000lb. all-aluminum liftgate with integrated cart stop, and single rear swing door. The tool truck also features a 19,000 BTU LP furnace with an underbody mounted propane tank and a color backup camera system. Prep has already been done for a rooftop A/C unit as well.
Inside is an L-shaped desk with ColorCore drawers, a microwave, monitor, hidden countertop extension and a lighted knife display on the front. Black slat wall provides additional display space around the desk as well as throughout the vehicle. James opted to include a double repair stack with the carpeted hammer rack mounted to the bulkhead. Pegboard with lacing has been installed to utilize the additional space underneath. A jack display has also been added to the side of the repair stack as well. Moore also included an air tool ladder, dual Sliding Displays,
An air tool ladder, dual Sliding Displays, and a torque wrench display have also been added throughout the vehicle. Chrome magnets provide additional display space on the promo shelving. A bank of VersaFlex drawers has been added to the street side along with six VersaFlex drawers installed right above the overstock bins on the curb side. Swirl plate provides durability on the bottoms of the three toolbox areas in the vehicle. Kenwood 6x9 speakers have also been added to pump the tunes while on the route and at a stop.